Hold a pin against the hard solder and heat the reverse side of the
board. When the solder gets hot the pin slides through the board and
creates a clean hole with the shaft of the needle. The cool metal of the
needle cools the solder and makes a tunnel shape of solder on the hot
side of the board. Use care, a metal pin sometimes gets hot (Like
McDonald's coffee) Also pins are sharp.
New tips are welcome and encouraged. Tips will be credited to those who
contribute. If you would like to submit a tip click
here.
For more information you may contact us by email or by phone at (801)
277-6296 (voice and message), or (801) 277-0888 (message).
