Selenium rectifiers (diodes) were used by Genco and others in the 1940s and
early 1950s to provide crude DC operating voltage for the game. They appear
as a stack of disks (sometimes square) about 3 inches round, with 3 wires
running to them. Usually connected to a 'center-tapped' transformer,
providing full wave rectification. Beware if you get one of these games
from long-term storage. The 'diode' can be weak from disuse, and the
machine should first be 'powered-up' through a Variac, or other voltage
reducing means. Gradually increase the voltage, starting at about 25, over
a period of hours, to reach regular house currant. It helps to gently heat
the diode with a hair dryer, but don't over-do it! Don't operate the
machine during this; and keep a close watch for sparks/smoke! I've found
this successful in keeping the original diode (actually, this setup uses 2,
back-to-back; but that's getting picky about names!) Otherwise, it's better
to just replace this giant selenium unit with 2 regular diodes. If they do
burn, it smells like rotten eggs!
New tips are welcome and encouraged. Tips will be credited to those who
contribute. If you would like to submit a tip click
here.
For more information you may contact us by email or by phone at (801)
277-6296 (voice and message), or (801) 277-0888 (message).
