Make sure that you follow the instruction manual for the tumbler.
If there wasn't one, make sure that the tanks are clean inside and
out, put a drop of fine oil, like sewing machine oil, on the ends
of each of the rollers, and make sure that the belt is as loose as
possible while still being able to turn the rollers under load. This
will prolong the life of the tumbler, and result in a better end product.
Use different
sized stones. You won't get a very good result if the stones are
the same size. With a 3 pound tank, it should be loaded about 1/2
to 3/4 full of stones, and of these, the large size should be about
1" in diameter, with about a quarter or more of the stones
being smaller. Keep in mind, though, that the polishing process
can remove 20% of the stone, so very small stones may be ground
to such a small size that they aren't worth much.
Polishing
the stones:
Keep in mind
that all of these steps take a lot of time.
First, load
the tank. It should be 1/2 to 3/4 full of stones. Too few stones,
and the result will be poor. Too many, and it puts too much of a
burden on the tumbler and may burn out the motor or break the belt.
Make sure that the seal is firmly seated on the tank and put it
on the tumbler.
Add water to
about 1/4 of the way deep on the top layer of stones. To this, add
2 tablespoons of coarse grit. This is 60 to 90 grit size (relatively
large grit).
Run the tumbler
for about an hour, making sure that it is rotating properly. At
the end of an hour, check for water leaks, turn off the tumbler,
remove the tank, and carefully remove the top to release built up
gases. Replace the lid, reseating the seal, and turn the tank to
the tumbler, turning it on. Check it again in 24 hours, in the same
way. At that time, check the water solution. The grit should not
be clumped up, nor should it be a slurry, looking like pea soup.
Run the tumbler
for a week with the coarse grit, then stop and thoroughly clean
the stones with running water. (An old toothbrush is great for this
step, and subsequent cleaning steps.) Also clean out the tank well.
Important: When rinsing the stones in this, and later steps, do
not do so down the sink. The grit can plug drains.
Replace the
stones, again add water as before, and add 2 tablespoons of medium
grit. (Note that polishing grit is often sold in coarse, medium,
fine, and polish grades. Usually you don't have to ask for a specific
grit size.) Again run the stones in this solution for a week.
Repeat this
process using fine grit, and run for 7-10 days. Then move to pre-polish
grit and polish grit. With this last step, it is helpful to include
some of the small plastic pellets that are made specifically for
this purpose, to prevent the rocks from scratching each other or
chipping.
Between each
step, make sure that you clean off the rocks and both the inside
and outside of each barrel. After the polish step, if you remove
any of the stones and find that it is cloudy rather than glossy,
run the tank a final time with water and a small amount of mild
powdered soap (NOT detergent) like Ivory.
This is very
time consuming, but done properly, this will turn rough uninteresting
stones into things of beauty, and perhaps some, into semi-precious
stones that are totally gorgeous.
Copyright ©
2008 Rex Trulove- All Rights Reserved
Reprinted with permission - Rex
Trulove
|