* levcap-h.m - hollow in back of lever cap
* Yehle infill plane
* Oriented bottom up, tip at left
* tip is X=0, bottom surface (up) is Z=0
* y=0 is edge near operator (eventual right)
* Tool is 3/8" end mill w/ corner radius
Rapid      Z 0.1
Rapid      X 1.5206 Y 0.6824
Line       Z -0.04 Feed 1.0
Call 1
Line       Z -0.08 Feed 1.0
Call 1
Line       Z -0.12 Feed 1.0
Call 1
Line       Z -0.16 Feed 1.0
Call 1
Line       Z -0.20 Feed 1.0
Call 1
Line       Z -0.24 Feed 1.0
Call 1
Line       Z -0.28 Feed 1.0
Call 1
Line       Z -0.32 Feed 1.0
Call 1
Line       Z -0.36 Feed 1.0
Call 1
Line       Z -0.40 Feed 1.0
Call 1
* Take down the remaining pillar at center
Rapid      Z 0.1
Rapid      X 1.75 Y 1
Line       Z -0.4 Feed 3.0
Rapid      Z 0.1
EndMain
*
Sub 1
* Entry/Exit: X=1.5206 Y=.6824 Z=plunged
Line       Y 1.3976 Feed 6.0
Arc Ccw    X 2.0877 Y 1.1004 Radius 1.5054
Line       Y 0.9796
Arc Ccw    X 1.5206 Y 0.6824 Radius 1.5054
EndSub