* STEMSLOT.M - A13 9" infill smoothing plane
* Jim Yehle - Salt Lake City - Jan 18, 2003
* Mortise for adjuster stem in handle
* lower-front of handle is left, left edge at x=-3.073,
*  Y=0 is centerline (pivot-center is at x,y = 0,0)
*  Z 0 is at the plane of the iron bed
* This can be run right after ADJ-MORT.M
* TOOL #6 is 3/8" diam.  ball end mill
Dim Abs
Rapid      Z 0.1
Rapid      X 0 Y 0 Tool# 6
* out and back on centerline (back is deeper)
Rapid      Z -0.09
Line       X 2.1 Feed 5
Rapid      Z -0.16
Line       X 0
*
Rapid      Z -0.22
Line       X 2.1 Feed 5
Rapid      Z -0.27
Line       X 0
*
Rapid      Z -0.32
* Accomodate swivel by slope of 1/16" over 2"
Line       X 2.1 Y -0.065
Rapid      Y 0.065
Line       X 0 Y 0
Line       X 1 Feed 15
Line       X 2.1 Feed 8
Rapid      Z 0.1