* THRPLATE.M --  Yehle #13 9" smoothing plane
* Throat plate behind iron
* Sub 1 cuts 50 degree bevel (York pitch)
* Sub 2 drills holes for riveting
* You need to re-fixture & locate part between
Dim Abs
Call 1
*Dwell 0.0
*Call 2
EndMain
*
Sub 1
* Angle at front, piece held vertically
* Eventual bottom of part is toward operator
* Extends left of vise, w/.848 max. in vise (of 1.25)
* X=0 at (eventual) sharp lower edge of part
* Y=0 at (eventual) bottom of part
* You'll plunge Z during Dwell
* Tool is 3/4" end mill
Rapid      X -0.2873 Y 0.2410
* Plunge Z now
Dwell 0.0
Line       X 0.0274 Y 0.6160 Feed 2.0
* You can plunge more, and I will return
Dwell 0.0
Line      X -0.2873 Y 0.2410
EndSub
*
Sub 2
* holes for riveting, in throat plate
* Beveled front edge at left, at x=0; Y=0 is centerline of sole
* Held flat, top up; Z=0 is flush with top
* (Bozo note: watch out for your parallels! 1/8" max thickness)
* Tool is 3/16" diameter centercutting end mill
*
Rapid      Z 0.1
* Drill/countersink three 3/16 holes for rivets
Rapid      X 0.5168 Y 0.625 Tool #3
Dwell 0
Rapid      X 0.5168 Y -0.625
Dwell 0
Rapid      X 1.0168 Y 0
Dwell 0
EndSub