* y13rside.m - Yehle #13 9" smoothing plane
* Right side plate, held horizontally
* Cuts top profile only
* Front of part is toward left
* Part zero is: x=0 at front edge,
*  y = -1.95 is top of side
*  (the edge toward operator)
* Z is plunged to depth you want cut
* (run program once at each depth)
* Tool 14 is 1/2" mill (or chamfer)
* These feed rates are good if part was
*  rough-cut with saw to within 1/8" on 
*  front/rear, not at all on uppermost curve.
* At 80% feed cutting .03/pass in C1018 steel
Rapid      Y -2.5 Tool# 14
Rapid      X 9.5
Rapid      Y -1.0
Line       Y -0.6613 ToolComp Left Feed 20.0
Line       X 9.0000 Feed 3.0
Line       X 6.7616 Y -0.9897
Arc Ccw    X 5.2062 Y -1.9500 Radius 2.3497
* Won't cut anything if stock is 2" exactly
* (unless using chamfer mill: if so, lower Feed rate)
Line       X 4.0324 Feed 10.0
Arc Ccw    X 3.4522 Y -1.8105 Radius 0.5474 Feed 1.0
Arc Cw     X 2.7143 Y -1.7185 Radius 0.8553
Arc Ccw    X 0.9579 Y -0.9807 Radius 3.4823 Feed 3.0
Line       X 0.0000 Y -0.8439
Line       X -0.5 Feed 20.0
Line       Y -1.5 ToolComp Off
Line       Y -2.5 Feed 20.0 Tool# 0
* Can just lower cutter and run again, unless
* something is in the way between X=0 and 9.5
* (e.g. if you're slot-milling from plate stock,
*  which I guess is possible; small mill, slow feed)