Mr. Pinball Tip:

I tried rubber tubing to plastic and cardboard washers to get the xylophone sound but to no avail. I finally found something that works, is easy to find and cheap too. First cut two (or 4) 1 and 1/2 inch squares off 3M pad. put holes in the middle and slide one (or 2) down each post the tone bar goes on. Then put on the tone bar. Then put retaining bar on top of that and slide the retaining pin through the posts. The final step is to use an elastic hair tie, and loop it under the retaining bar but above the tone bar. Lift the tone bar upwards so that it does not touch the elastic hair tie. The result is a nice tone when struck.

Wayne Jones

Tip Archive

New tips are welcome and encouraged. Tips will be credited to those who contribute. If you would like to submit a tip click here.

For more information you may contact us by email, email form, or by phone at (801) 277-0888.
Go to: Home page, Photo Gallery, Classified Ads, Repair Tip of the Day, The Pinball Collector Register, Advertisers List, Site Map
© Copyright Mr. Pinball 2024. All Rights Reserved.